FP-AS510 Paddle Wheel Flowmeter Instruction Manual
  • ⚠Safety instructions
  • This instruction manual version is v1.0
  • Measure principle and usage scenario
  • Warranty
  • Exterior, Spec, Model
    • Device
    • Paddle set
    • T-connector
  • Install and set-up
    • Mechanism installation
    • Mechanical and electrical installation
    • Parameter setup
  • Human machine interface
    • Introduction of human machine interface
    • Monitoring screen
    • Data interpretation on monitoring screens
    • Setup screen
  • Communication
    • OCT output
    • 4-20mA
    • RS485
    • Modbus RTU Protocol
      • Read-only memory read instruction(04) and memory lists
      • Read-write memory list
      • Read-write memory read instruction(03)
      • Read-write memory single Register write instruction(06)
      • Read-write memory double Register write instruction(30)
  • Parameters Table
  • Alarm and description of system conditions
  • Trouble and abnormality shooting
  • Certification
  • FP-AS510 Product Page
  • LORRIC English Website
  • LORRIC Integration and Application Center
Powered by GitBook
On this page

Was this helpful?

Export as PDF

Install and set-up

PreviousT-connectorNextMechanism installation

Last updated 5 years ago

Was this helpful?

Notices before installing

Confirm the version of the instruction manual, hardware, and firmware.

  • Make sure that the installation environment meets the standard for flow volume monitoring. There should be a certain distance in front and after the location of the installed flowmeter. The proper position for the flowmeter should be face up horizontally or vertically depending on the flow direction.

  • Confirm temperature and chemical resistance, and the size of pipes.

  • Ingredients in chemicals and operating temperatures will differ according to industry. Before purchasing the flowmeter, please confirm these specifications to avoid any damage to the flowmeter.

  • Please avoid measuring fluids with magnetic particles which may cause LORRIC’s paddle wheel flowmeter to work improperly. The reason being, is the paddlewheel uses magnetic flow sensor technology. In addition, we suggest placing it at a distance from equipment which may generate a strong magnetic field, like motors and electromagnetic valves.

Go to version page to check.