LogoLogo
FU-ES Flow Meter English Manual v1
FU-ES Flow Meter English Manual v1
  • ⚠Safety Instructions
  • This instruction manual version is v1.0
    • Manual Update Log
  • Measurement principle and usage scenario
    • Firmware Update Date and Version Feature Description
  • Warranty
  • Exterior, Specs, Model
  • Installation and Setup
    • Mechanism Installation
    • Mechanical and Electrical iInstallation
    • Parameter setup
      • Z02 Automatic Pipe Size Detection Guide
  • Human Machine Interface
    • Introduction of human machine interface
    • Hybrid Page Setup and Usage Interface Guide
    • Monitoring Screen
    • Simulation Mode
    • Data interpretation on monitoring screens
    • Password input page
    • Setup screen
  • Communication
    • OCT output
    • Analog current output (0-20mA, 4-20mA)
    • RS485 and Modbus RTU Setting
    • Modbus RTU Protocol
      • Read-only memory read instruction(04) and memory lists
      • Read-Write Memory List
      • Read/Write Memory Read Command (03)
      • Read-write memory single Register write instruction(06)
      • Read/Write Memory Dual-Register Write Command (30)
      • Read/Write Memory Four-Register Write Command (31)
      • Single Bit Data Read/Write Commands (01/05) (Commonly Used in HMIs)
  • Parameters Table
    • Z Category Options and Descriptions
    • A Category Options and Descriptions
      • A02 Preset Pipe Specification Table for Different Models
      • A03 ~ A07 Data Range Explanation Based on Model Specifications
    • B Category Options and Descriptions
    • K Category Options and Descriptions
    • C Category Options and Descriptions
    • D Category Options and Descriptions
    • E Category Options and Descriptions
    • F Category Options and Descriptions
    • H Category Options and Descriptions
    • Pagasfsae 1
    • Page 1
  • Common Usage Scenarios
    • Dosing Flow Meter Operation Guide
  • Alarm and description of system conditions
  • Troubleshootings and Abnormalities
    • Iout 4-20/0-20mA debug process
    • OCT Alarm Debug Process
    • OCT Pulse Debug Process
    • RS485 Debug Process
  • Certification
  • FU-ES Product Page
  • LORRIC English Website
  • LORRIC Integration and Application Center
Powered by GitBook
On this page
  • F01 Sim. Rate (Simulation Rate) - Simulated Flow
  • F02 Sim. Mode (Simulation Mode)
Export as PDF
  1. Parameters Table

F Category Options and Descriptions

F01 Sim. Rate (Simulation Rate) - Simulated Flow

Defines the instantaneous flow rate to simulate. The unit applied will follow the settings defined in the B classification parameters.

Parameter Input Range
Value

Data Type

float32

Default

60

Minimum

-100000

Maximum

100000

F02 Sim. Mode (Simulation Mode)

Activating this option enables the simulation function, which is disabled by default. When enabled, the OCT outputs (excluding pulse), RS485 communication, and analogue current output will operate based on the simulated data and changes in the totalised flow.

  • Please note that the totalised flow and historical data will be affected.

  • The main screen will display an indication that the system is in simulation mode. Ensure the relevant communication functions are enabled for proper operation.

    Options
    RS-485 Numbers
    Remarks

    OFF

    0

    Default

    ON

    1

After selecting a command, confirm whether to Save or Not Save.

PreviousE Category Options and DescriptionsNextH Category Options and Descriptions

Last updated 4 months ago