LORRIC Docs For Partners
FU-TX 310 Clamp-on Ultrasonic Flowmeter Manual v2.
FU-TX 310 Clamp-on Ultrasonic Flowmeter Manual v2.
  • This instruction manual version is v2.1
  • 1. Product Introduction
    • 1.1 Specifications
    • 1.2 Important concepts
    • 1.3 Product features
    • 1.4 Product applications
    • 1.5 Measuring principle
    • 1.6 Product contents
    • 1.7 User interface
      • 1.7.1 Screen interfaces
      • 1.7.2 Buttons
      • 1.7.3 LED message
  • 2. Installation Method
    • 2.1 Power
    • 2.2 Ultrasonic probe
      • 2.2.1 Probe wiring
      • 2.2.2 Meter wiring
      • 2.2.3 Installation location
      • 2.2.4 Installation method
      • 2.2.5 ​Probe installation method
    • 2.3 Temperature sensor/Analog output
      • 2.3.1 Temperature sensor
      • 2.3.2 Analog output
      • 2.3.3 Wiring method
    • 2.4 Installation check
      • 2.4.1 RSSI (Signal Strength)
      • 2.4.2 Q value
      • 2.4.3 Flight time
  • 3. Output Interface
  • 4. Setting up the Interface
    • 4.1 Intial menu settings
    • 4.2 Units
    • 4.3 Meter (Measurement Settings)
    • 4.4 Communication
    • 4.5 Other
    • 4.6 Save
  • 5. Error Messages and Solutions
  • 6. Other Conditions
  • 7. MODBUS Communication Protocol
  • 8. Cautions
  • 9. Sound Speeds Data
  • LORRIC Integration and Application Center
Powered by GitBook
On this page
  1. 1. Product Introduction
  2. 1.7 User interface

1.7.2 Buttons

Previous1.7.1 Screen interfacesNext1.7.3 LED message

Last updated 5 years ago

There are four buttons at the bottom of the screen; their corresponding functions are shown on the lower edge of the screen:

From left to right order of view: Button one:

● Switch the interface.

● Back to the previous level (the multi-level interface).

Button two:

● When < ​is displayed: Returns to the previous option or interface; moves between choices after entering the interface.

● When +​ is displayed: Edit the number.

Button three:

● Select the next menu or interface.

● When editing numbers, jump to the next digit.

Button four:

● When ENT​ is displayed: Press Enter to enter the selected menu.

● When SET​ is displayed: Press to set the content entered.

● When PAUSE​ is displayed: Press to pause measurement, Red light will flash.

● When START​ is displayed: Press to continue measurement and release PAUSE​ status.