FU-TX 310 Clamp-on Ultrasonic Flowmeter Manual v2.
  • This instruction manual version is v2.1
  • 1. Product Introduction
    • 1.1 Specifications
    • 1.2 Important concepts
    • 1.3 Product features
    • 1.4 Product applications
    • 1.5 Measuring principle
    • 1.6 Product contents
    • 1.7 User interface
      • 1.7.1 Screen interfaces
      • 1.7.2 Buttons
      • 1.7.3 LED message
  • 2. Installation Method
    • 2.1 Power
    • 2.2 Ultrasonic probe
      • 2.2.1 Probe wiring
      • 2.2.2 Meter wiring
      • 2.2.3 Installation location
      • 2.2.4 Installation method
      • 2.2.5 ​Probe installation method
    • 2.3 Temperature sensor/Analog output
      • 2.3.1 Temperature sensor
      • 2.3.2 Analog output
      • 2.3.3 Wiring method
    • 2.4 Installation check
      • 2.4.1 RSSI (Signal Strength)
      • 2.4.2 Q value
      • 2.4.3 Flight time
  • 3. Output Interface
  • 4. Setting up the Interface
    • 4.1 Intial menu settings
    • 4.2 Units
    • 4.3 Meter (Measurement Settings)
    • 4.4 Communication
    • 4.5 Other
    • 4.6 Save
  • 5. Error Messages and Solutions
  • 6. Other Conditions
  • 7. MODBUS Communication Protocol
  • 8. Cautions
  • 9. Sound Speeds Data
  • LORRIC Integration and Application Center
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. 1. Product Introduction
  2. 1.7 User interface

1.7.2 Buttons

Previous1.7.1 Screen interfacesNext1.7.3 LED message

Last updated 5 years ago

Was this helpful?

There are four buttons at the bottom of the screen; their corresponding functions are shown on the lower edge of the screen:

From left to right order of view: Button one:

● Switch the interface.

● Back to the previous level (the multi-level interface).

Button two:

● When < ​is displayed: Returns to the previous option or interface; moves between choices after entering the interface.

● When +​ is displayed: Edit the number.

Button three:

● Select the next menu or interface.

● When editing numbers, jump to the next digit.

Button four:

● When ENT​ is displayed: Press Enter to enter the selected menu.

● When SET​ is displayed: Press to set the content entered.

● When PAUSE​ is displayed: Press to pause measurement, Red light will flash.

● When START​ is displayed: Press to continue measurement and release PAUSE​ status.