A13 K.Viscosity cst

Definition

Set the fluid dynamic viscosity. Default: 1.

Notes

When the user sets A10 (Fluid Type), A13 (Fluid Dynamic Viscosity) will be updated accordingly based on the A10 selection.

Operation Procedure

Button Functions (Click to Expand)

The main unit has four buttons. The bottom line (Line 3) of the LCD displays the current function of each button. Under normal operation, the button functions are as follows:

• Blue Button - Leftmost button: Return, exit, or save settings.

Gray Arrow Buttons:

• Left Gray Button: Previous Page, decrease value, or select item

• Right Gray Button: Next Page, increase value, or select item

• Orange Button: Rightmost button: Enter settings, edit, or confirm selection

Do not hold buttons for extended periods to avoid damage.

Button functions may change depending on the operation context to improve usability or prevent accidental presses.

A13 K.Viscosity cST Setting Steps
• From the main screen(green backlight), 
  press Orange Button(Setup) to enter settings (orange backlight).
• Use Gray Arrow Buttons to select A. Measurement, press Orange Button(Enter).
• Use Gray Arrow Buttons to select A06 Pipe Thickness, press Orange Button(Enter).
• Use Gray Arrow Buttons to choose the digit to adjust(highlighted in dark gray).
• Press Orange Button(Edit) to enter adjustment mode.
• Adjust digits: Left Gray Button to increase, Right Gray Button to decrease.
• Press Orange Button(Set) to confirm each digit; repeat for other digits as needed.
• After all digits are set, press Blue Button(Save).
• Confirm by pressing Orange Button(Save) (or Blue Button(NOT) to cancel).
• Press Blue Button(ESC) to return to the main screen(green backlight).

A13 Options, RS485 Values, Read/Write Commands, and Formats

Input Range of This Parameter	Corresponding Values	RS-485 value
Default	1	-
Minimum	0.05	-
Maximum	20000	-

Refer to the Read/Write Memory List for the Modbus command format. This parameter uses the float 32 data format.