F03 Sim. PulseHz

Definition

Sets the simulated OCT pulse output frequency, in pulses per second (Hz). Range: 0–700. Default: 0.

Notes

1. Set E01 NC/NO to define the pulse output state (Normally Closed or Normally Open) before enabling this function.

2. Set E03 Pulse Width to define the duration of each output pulse.

3. The pulse signal operates regardless of whether the OCT output function is enabled.

Operation Procedure

Button Functions (Click to Expand)

The main unit has four buttons. The bottom line (Line 3) of the LCD displays the current function of each button. Under normal operation, the button functions are as follows:

• Blue Button - Leftmost button: Return, exit, or save settings.

• Gray Arrow Buttons:

  • Left Gray Button: Previous Page, decrease value, or select item

  • Right Gray Button: Next Page, increase value, or select item

• Orange Button: Rightmost button: Enter settings, edit, or confirm selection

Do not hold buttons for extended periods to avoid damage.

Button functions may change depending on the operation context to improve usability or prevent accidental presses

F03 Sim. PulseHz Setting Steps
• From the main screen(green backlight), 
  press Orange Button(Setup) to enter settings (orange backlight).
• Use Gray Arrow Buttons to select F. Simulate , press Orange Button(Enter).
• Use Gray Arrow Buttons to select F03 Sim. PulseHz, press Orange Button(Enter).
• Use Gray Arrow Buttons to choose the digit to adjust(highlighted in dark gray).
• Press Orange Button(Edit) to enter adjustment mode.
• Adjust digits: Left Gray Button to increase, Right Gray Button to decrease.
• Press Orange Button(Set) to confirm each digit; repeat for other digits as needed.
• After all digits are set, press Blue Button(Save).
• Confirm by pressing Orange Button(Save) (or Blue Button(NOT) to cancel).
• Press Blue Button(ESC) to return to the main screen(green backlight).

F03 Options, RS485 Values, Read/Write Commands, and Formats

Parameter Input Range	Corresponding Values	RS-485 Value
Default	10 Hz	-
Minimum	0 Hz	-
Maximum	700 Hz	-

Refer to the Read/Write Memory List for the Modbus command format. This parameter uses the const (Constant) data format and is read-only